Setech ST-EG100-E Betriebsanweisung PDF herunterladen (Seite 17)

ST-EG100-E Installation and User Guide Configuration

each email address is 48 characters and each corresponding Message may be up to 255

characters.

To enter an email address, left-click in the Email Address cell and enter the email address.

8. Left-click in the adjacent Message cell and enter the message to be sent to the email address.

If a specific set of Rules criteria that was defined using the Whenever/And/Then rules

programming of the ElkRP2 is met, the message is generated and distributed. Refer to

ElkRP2 documentation for instructions on defining Rules.

The following is an example of a Rule to send a message to send an email message when the

system is disarmed by a particular user. The system sends an email to Mom’s email address

(mom@office.job) when Mike has arrived home.

WHENEVER House (Area 1) STATE BECOMES DISARMED

AND LAST USER WAS Mike (User 4)

THEN SEND EMAIL MESSAGE 1 TO [email protected] (Email 1)

9. Using the Virtual Keypad (refer to Section 4.4.6.1), the ST-EG100-E provides the unique

ability to define email groups that are used to send the same notification to multiple email

addresses. For example, creating a group named “Mom & Dad” that includes the email

addresses for both mom and dad (mom@office.job, [email protected]), ensures that both

parents are notified when Mike arrives home.

10. Activate the Send button to save Email configuration changes to the ST-EG100-E. Refer to

steps 15 through 19 of Section 3.3 for instructions on sending changes to ST-EG100-E and

saving to local ElkRP2 database.

11. To send a test email, activate the Test button. Please note that this is the only time the ST-

EG100-E can send an email message while connected to ElkRP2. The ST-EG100-E attempts

to send email message 1 to the recipient listed for that message. After a few minutes, check

the recipient’s inbox to verify receipt of email.

3.4.2.1. Enhanced Email Notification (EEN)

Another advanced feature of the ST-EG100-E is that the user can define detailed contents for

each email message sent for a specific event (e.g. Area House is disarmed by user Mike), along

with ability to send the message to additional users. Embedded dynamic reports such as Zone

Status, Zone Alarm, and Area Status may also be included in the body of HTML format email

messages.

The following is a list of keywords used to define the contents and distribution of an email

message. These keywords are entered in the “Message” field. Each keyword is enclosed by

matching delimiters, i.e. curly brackets “{“ and “}”.

SETECH Security & Automation Revision 1

96-300001 Page 17 of 44

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 43 44

Keine Kommentare

Setech ST-EG100-E Betriebsanweisung Seite 17